If you know how to perform basic repairs, you can make your appliances last much longer, which can save you a lot of money. In this article, we are going to help you replace your fridge micro switch. In the beginning, it may not be easy for you to replace the unit. However, if you follow the steps given below, you will find it much easier to perform the replacement.
1: Get the Tools you Need
· Duct tape
· Putty knife
· Flat blade screwdriver
· Micro switch
2: Disconnect the Power
Before you work on any type of electrical appliance, make sure you disconnect the power supply first. It is important for your safety and the safety of everyone around you. So, make sure you have disconnected the power supply.
3: Take off the Drip Tray
Your next step is to remove the drip tray. This part is located at the bottom of the unit. You can use duct tape in order to protect the finish. Next, you should put the putty knife below the escutcheon and then pull it down and out in order to separate it.
You will see that it is connected to different spots. Therefore, you should start at the bottom and pull it out by tilting it first.
After the drip tray has been removed, you will find the 5-pin plug. This is a component that is a power source for the switches. All you need to do is disconnect the plug and put it aside before following the next step.
4: Remove the Old Micro-Switch
Now you can access the micro switch. They will be fixed with the help of plastic tabs and hooks. First of all, you should pull the hook and set it aside. Once you have removed the switch, you can easily pull it. You can use a flat blade screwdriver to remove the wire connector. This is the old micro switch that you need to replace.
5: Install the New Switch
Now you need to follow all of the previous steps in reverse. You can get the new switch and connect it to the wire connector. It should be properly fixed. Now, you can rotate it into the position while lining up the diagonal holes with the plastic posts. Next, you may want to push it
over in order to fix the locking caps. Lastly, you should everything to ensure all of the wires are out of the way.
6: Reconnect the Switches
Once you have replaced the micro switch, you can reconnect the connector. Make sure that the locking tab is in place. Next, you should elevate it in order to ensure it is over the dispenser housing. You can then tap it to ensure it is locked in place.
7: Finish Up
Once you have installed the new switch and reconnected the power, your final step is to replace the drip tray.
So, these are just a few simple steps that you can follow in order to replace your fridge micro switch.
RB:If you want to buy micro switches, you can buy from a china micro switches manufacturer. UnionWellPortual can be checked out at https://www.unionwellportugal.com/